13 - Have a friend hold the graphic in position without touching the car.  The graphic should be held approx. 1 inch away from the car.  Start to squeegee graphic from the center of the graphic working your way out to force the water out of the top and bottom of the graphic.  First use light strokes, and then use harder ones to remove the water.  Take your time and do a good job so the graphic adheres correctly.

14 - Let the graphic set for awhile until it drys.   If it is a warm day you can let the car sit out in the sun.   If it is a cool day and you want to speed up the drying process you can warm the graphic up with a hairdryer.

15 - Slowly and carefully peel the transfer sheet away from the graphic.  If the graphic moves around and isn’t sticking to the car , it’s still too wet.  You will have to wait for it to dry longer or use a hairdryer to dry it.

16 - ** It is very important to take your time and peel the transfer sheet away slowly.  You may run into problems if you go too fast.  Have a friend keep an eye on any of the smaller graphic pieces… one person may have to hold these pieces down while the other person peels the transfer sheet away. 

17 - Looking good so far !

18 - Use your x-acto knife to trim down your door seams / wheel wells.  Open your door once both the seams are cut and tuck the edges away.  If you are having a hard time getting them to stick you may have to wait for it to dry longer.  A heatgun/hairdryer can be used to speed up the process.